Simco Fmx002 Manual ((new)) Full Jun 2026

The device is intended for clean environments. Exposure to water, oil, or solvents will cause failure.

Do you need the wiring pinout for the ?

A flat, polished aluminum plate (typically 6" x 6") mounted on an insulated stand.

The Simco FMX-002 is a compact, handheld, electrostatic field meter used to measure static charges on surfaces. It is designed to be user-friendly while providing accurate measurements of electrostatic fields up to ± 20kV (20,000V) at a distance of 1 inch [1]. Key Features of the simco fmx002 manual full

If the device behaves unexpectedly, refer to the following guide: Potential Cause Battery empty or poor contact. Replace the battery or check contacts. Cannot set zero Meter is in HOLD mode or zero point has shifted.

The device utilizes a microprocessor-controlled interface for ease of use in challenging factory environments: One-Touch Zero:

features a highly rugged, pocket-sized design featuring three essential interactive zones: FMX – 003 The device is intended for clean environments

The Simco FMX002 manual provides a comprehensive guide to understanding and operating the device. By following the step-by-step instructions and tips outlined in this blog post, you'll be able to get the most out of your Simco FMX002 and ensure safe and effective operation.

Disclaimer: This article is for informational purposes. Always refer to the original manufacturer’s documentation for absolute safety and operating procedures.

| Problem | Potential Cause | Solution | | :--- | :--- | :--- | | Device won't turn on. | Dead or incorrectly installed battery. | Install a new 9V battery, ensuring correct polarity. | | Erratic or inconsistent readings. | Weak battery / Unreliable ground connection. | Replace the battery / Connect the grounding wire securely. | | ERR message on display. | Internal sensor damaged. | Return the device to a certified service center for repair. | | Reading is always "0". | Far exceed measuring distance (25mm). | Move the meter closer until LEDs converge into one spot. | | Excessive interference/noise. | Nearby strong magnetic fields. | Relocate the measurement away from sources of interference. | A flat, polished aluminum plate (typically 6" x

Turn on the device by pressing the button once. The unit will beep.

Unit was not zeroed correctly or is missing its ground connection.