Resetter Printer Canon G2010

Printers track ink usage during cleaning cycles. When the internal counter reaches a certain limit, the printer assumes the waste ink sponge is saturated and halts all printing to prevent overflow. Common symptoms include: appearing on your computer. The Alarm and ON lamps flashing alternately 7 times.

Make sure the printer is connected to your Windows computer via a stable USB cable. Note: Service Mode tools do not work over Wi-Fi.

Press the button on the printer to turn it off. (It may take a few seconds to shut down completely). Disconnect the USB cable from the computer.

A critical analysis of the resetter must address the physical reality: resetting the counter does not reset the physical sponge. resetter printer canon g2010

To reset a Canon PIXMA G2010, you can use manual button sequences to enter for internal errors like "Ink Absorber Full" (Error 5B00) or use software tools for a more permanent digital reset. Manual Reset (Error 5B00 / P07)

If the manual method doesn't work, the WIC Reset Utility is a highly reliable software-based alternative. It is a third-party tool specifically designed to reset waste ink counters for many Canon printers, including the G2010. You will need to download the free tool, but you must purchase a "Reset Key" to activate it for a one-time use, making it a paid option.

Turn off the printer by pressing the button (it may take a few seconds to shut down completely). Printers track ink usage during cleaning cycles

Use this method to restore original factory settings for general troubleshooting. the printer.

The most prevalent method involves the "Canon Service Tool" (versions typically range from v1074 to v3600 for the G-Series). This proprietary software, leaked from authorized service centers, allows direct communication with the printer's firmware.

Look further down the tool for the Ink Absorber Counter section. Ensure Counter Value (%) is set to 0 and click Set . The Alarm and ON lamps flashing alternately 7 times

Keep holding the Power button, then release the Stop/Reset button.

Typically 2–3 times. After the third or fourth reset, the physical pads will be so saturated that any reset will cause immediate leakage. At that point, you must replace the pads.

Right-click on the Service Tool.exe file and select Run as administrator .

Look at the top tab labeled Main . Locate the Clear Ink Counter section. Next to Absorber , make sure Main is selected in the dropdown menu. Apply the Reset: Click the Set button right next to it.

By following this step-by-step guide carefully, you can successfully bypass the Canon G2010 5B00 error, saving time and avoiding expensive repair technician fees.