Nokia 7250 Ixr X1 Installation Guide Today

Scrape away any paint around the grounding pad if necessary to establish a metal-to-metal connection. Attach a 6 AWG copper grounding wire to a dual-hole lug.

Installation Guide for the Nokia 7250 IXR-X1 The is a high-performance, 1RU (Rack Unit) interconnect router designed for high-density 10GE to 400GE aggregation in data center and 5G networks. This guide provides a summary of the physical installation and initial setup procedures. 1. Site Preparation and Safety

Contact Nokia Technical Support: 1-888-665-4252 (US) or your local support center.

Confirm that the new version is active and that all configuration elements are intact. nokia 7250 ixr x1 installation guide

The 7250 IXR-X1 utilizes front-to-back or back-to-front cooling. Maintain at least 4 inches (10 cm) of clearance around ventilation intake and exhaust ports.

With physical installation complete, you must initialize the software operating system (Nokia SR OS). Connecting via Console Port

The 7250 IXR X1 supports two primary methods for initial software installation: Scrape away any paint around the grounding pad

Never operate the Nokia 7250 IXR-X1 without a verified chassis ground connection.

Attach the provided mounting brackets to the sides of the IXR-X1 chassis.

Lift the router chassis out of the box using structural points; do not lift the chassis by the fan modules or power supplies. Verify that all ordered components match the packing list: Nokia 7250 IXR-X1 chassis Power Supply Units (PSUs) – AC or DC variants Fan tray modules Rack-mounting bracket kit Grounding lug and screws Section 3: Mechanical Installation and Rack Mounting This guide provides a summary of the physical

Before unboxing the hardware, ensure the installation environment meets all structural and safety metrics to prevent equipment damage or personal injury. Environmental Requirements

Attach the lug to the chassis using the grounding screws and connect the other end of the wire to your facility’s primary earth ground. 3. Connecting Power

Secure the lug to the chassis using the two provided M4 screws. Tighten to approximately 15 in-lbs (1.7 Nm).