V1052 Verified Link — Firstchip Fc1178 Fc1179 Mptools

: Increases the flashing success rate when initialising Multi-Level Cell (MLC) storage modules.

Open the identification software and locate the and Controller Vendor .

Under , select Low Level Format for a deep clean, or High Level Format if the drive chip is healthy but the partition table is ruined. firstchip fc1178 fc1179 mptools v1052 verified

Includes a toggle on the side panel to switch from Chinese to for easier use. Verified Usage Guide

In the world of hardware repair, software fragmentation is a nightmare. FirstChip has released dozens of MPTools versions over the years—v1.0.3.4, v1.0.5.0, v1.0.6.6, and so on. Historically, each version was often hardcoded to work only with specific batches of controllers or specific NAND flash configurations. : Increases the flashing success rate when initialising

Click the button to begin the low-level flashing routine.

FirstChip FC1178/FC1179 MPTools V1.0.5.2 (released around June 2022) is a specialized factory programming utility used to repair and format USB flash drives using FirstChip controllers. It is widely used to fix "No Media," "Write Protected," or "Incorrect Capacity" errors often found in budget or counterfeit drives. Key Features of V1.0.5.2 Controller Support: Specifically designed for the (variants: 3D, BC, AB, S, E) and (variants: S, AB) series. Mass Production (MP): Includes a toggle on the side panel to

For most corrupted drives, the default factory settings work perfectly. However, if the drive fails on the first attempt, you must configure the parameters manually:

: Restoring the factory firmware when the original controller logic has failed. Capacity Restoration

: Run FCMpTools.exe . If the interface is in Chinese, look for the Language section in the right-hand column and select English .

| Error | Likely Cause | Fix | |-------|--------------|-----| | Flash ID mismatch | Wrong tool version or fake flash | Verify controller again; try older v1028 or newer v1061 | | Device removed during test | Poor USB connection or power | Use rear USB port; try USB 2.0 hub | | Load FW fail | Corrupted firmware in tool folder | Re-extract MPTools; disable AV | | Bad block too many | Physically failing NAND | Force lower capacity (e.g., 64GB → 32GB) in settings | | Not supported flash | Flash not in v1052 database | Find updated FirstChip_FlashDB.ini from a newer tool version |