Ericsson — Mini Link Cli Commands [new]

To make changes, enter the specific radio interface configuration mode:

| Command | Function | | :--- | :--- | | | Enter global configuration mode from user EXEC mode. | | write mem | The most critical command for configuration. It saves the current running-config to the startup-config , making changes permanent across reboots. | | set switchport | Used to configure Ethernet switch ports, including VLAN membership, speed, and duplex. | | add vlan / remove vlan | Commands to create or delete VLANs on the Ethernet switch. | | sync vlan | Used to synchronize VLAN configurations, often applied via management platforms. | | no ... | Prepend no to any configuration command to disable or remove a feature. For example, no rsyslog enable disables syslog forwarding. |

When a hop drops traffic or experiences high bit error rates (BER), use these diagnostic commands. Alarm Management

? – Type a question mark at any point to see available commands or arguments. help – Displays general help information. tab – Autocompletes commands or variables. Navigation Commands show – Displays current configurations and status. config – Enters configuration mode to modify parameters. ericsson mini link cli commands

The MINI-LINK CLI structure is hierarchical, resembling a folder tree. You move into specific configuration "contexts" to modify distinct hardware or software components. Basic Navigation Commands

When a link drops or throughput degrades, use these commands to parse active faults.

: Places a loop on a selected controller (e.g., E1) for link testing. no loopback : Removes the active loopback. To make changes, enter the specific radio interface

show alarms — Displays all active critical, major, and minor system alarms.

MINI-LINK uses standard protocols like FTP or SFTP to move files.

Always save your configuration modifications to non-volatile memory to prevent data loss during a power cycle. | | set switchport | Used to configure

MINI-LINK# show radio link # Link state, actual bitrate, modulation MINI-LINK# show radio performance # RSL, XPI, MUT, TX power MINI-LINK# show radio al0 # Adaptive modulation status MINI-LINK# show radio link-quality # BER, LOF, LOS, current and historic MINI-LINK# show radio hop-diagnostics # Detailed per-hop metrics (if multi-hop)

💡 : Use the ? key at any time to see available completions or the Tab key to auto-fill long command strings. I can provide more specific commands if you tell me:

The MINI-LINK CLI uses a hierarchical structure similar to standard network operating systems.