: Ensure your printer is connected to your computer via USB cable (Wi-Fi resetting is often unstable) and turned on. Run the Program : Open the AdjProg.exe file.

To ensure a smooth reset process, prepare your workspace and computer with the following steps:

Click on the button (located on the right side).

Using third-party service software on your Epson L3111 will almost certainly void your manufacturer's warranty. This action is intended for out-of-warranty printers.

This is a common issue built into inkjet printers to prevent ink from overflowing onto your desk. Fortunately, you do not need to buy a new printer or pay for expensive repair services. You can resolve this issue yourself using the Epson Adjustment Program (also known as the Epson Resetter).

: Ensure the printer is connected via USB ; these reset tools generally do not work over Wi-Fi.

For a visual walkthrough of the reset process, you can watch this demonstration:

Inside your Epson L3111, there are physical sponges designed to soak up excess ink during head cleanings and printing.

To fix the "Service Required" error on an , you can use the Epson Adjustment Program to reset the internal waste ink pad counter. This error typically occurs when the printer's sponges are digitally flagged as full, causing red lights to flash and the printer to stop functioning. Resetting the Waste Ink Pad Counter

, it does not physically clean the pad. To prevent ink leaks, it is recommended to eventually wash or replace the absorbent pad. Step-by-Step Fix Instructions

I can provide specific troubleshooting steps based on your current setup. Share public link

Ensure your printer is connected to your computer via USB and its drivers are properly installed. Launch Program: AdjProg.exe file as an administrator. Model Selection: button and choose from the model list. Adjustment Mode: Particular Adjustment Mode Counter Selection: Waste ink pad counter from the Maintenance section and click Initialization: Check the box for Main pad counter Platen pad counter if applicable). to confirm the current percentage. Initialize to reset the counters to 0%. when prompted, then turn off the printer and turn it back on to complete the reset. Alternative Tools

flashes lights and stops, it is because of the . Epson sets a limit to prevent ink from overflowing inside the machine. While the pads might not be completely saturated, the internal counter has reached its maximum.